• DisablingDaytimeRunningLamps
• BayAreaCorvetteShops
• DefectiveAlternatorInfo
• CorvetteC5OilChangeProcedures
• Bike Racks for the C5: Link #1 Link #2
• Vortex Rammer Installation

My Oil Change Record

Service done on 4-8-03

• New brakes pads, new rotors, new brake fluid
• Parking brake adjusted
• New diff fluid & flush
• New fuel filter
• Chasis graphite
• Front wheels rebalanced (Wheel Works put the weights in the wrong place)
• Power steering fluid flushed

C5 Idle Relearn Procedure

Purpose
This page basically shows you step by step how to do an Idle Relearn. You would want to do this if you have done any intake modifications. If you do not do this, you may have hesitation or other issues.
Tools Required
None.

Do the Job
Follow these procedures EXACTLY or you will have to start from scratch.

Insert key into ignition and turn to the "On" position but, DO NOT START THE ENGINE. 
Pop open the engine fuse block box cover and remove the two 10amp fuses from position numbers 16 & 23. 
Your DIC will now display "check" messages for ABS, etc... 
Turn ignition to the "Off" position. 
Re-insert both 10amp fuses for positions 16 & 23. 
Start your engine 
Allow engine coolant temperature to reach a minimum of 176 degrees F and run at this minimum temperature for at least 5 minutes. 
Shut down engine 
Let rest for a minimum of 30 seconds. 
Restart engine - check for DIC error codes (there should be none). 
Drive car for a minimum of 30 miles at varying rpm settings and speeds. PCM will now re-learn and adjust for the new air flow and air temperature at the intake. 

-- MattWalsh - 25 Jan 2002